Stanza Wagon 4WD L4-1974cc 2.0L SOHC (CA20E) (1988)
/Page-911006.png)
18.
On 1987-88 Maxima & Stanza, proceed as follows:
Fig. 7 Adjusting tie rod length. 1987-88 Maxima, Pulsar, Sentra & Stanza exc. 2WD Wagon
a. Tighten outer socket locknut so tie rod length ``L'' is 7.02 inches on Maxima and Stanza exc. 4WD Wagon or 6.88 inches on Stanza 4WD
Wagon and screwed length ``l'' is .98 inch or more on all models, Fig. 7.
Fig. 26 Measuring rack stroke. 1987-88 Maxima, Pulsar, Sentra & Stanza Exc. 2WD Wagon
b. Measure rack stroke, refer to Fig. 26. Note that dimension l1 is 2.24 inches on Maxima and Stanza exc. 4WD Wagon or 1.87 on Stanza 4WD
Wagon and dimension l2 is 2.76 inches on Maxima and Stanza exc. 4WD Wagon or 2.38 on Stanza 4WD Wagon.
19.
On all models, apply suitable sealing compound to contact surfaces between boot and cylinder, then install boot and boot clamps. Ensure boot
clamps do not interfere with any other parts. Also, use caution not to twist boot.
20.
Install cylinder tube.
21.
Apply suitable grease to pinion bearing, then coat threads of housing plug with suitable locking compound. Install housing plug and stake in three
places.
22.
On 1987-88 Maxima and Stanza exc. 4WD Wagon, install rear cover cap with alignment mark 10°-20° clockwise of neutral position.
