Titan 2WD V8-5.6L (VK56) (2004)
^
If the noise is still there, continue with this repair procedure.
7.
Completely lower the window.
8.
Remove the door finisher from the door the noise is coming from.
^
Refer to section EI in the Service Manual (ESM) for door finisher removal information.
NOTE:
The following tips will be helpful when removing the door finisher.
^
If the outside temperature is below freezing, 0°C (32°F), park the vehicle inside and wait until the vehicle has warmed to room
temperature. This will help prevent breakage of plastic trim parts.
^
There is a small notch in the bottom rear of the pull handle cover. Use a small flat blade screwdriver at this notch to pop the cover off (see
Figure 5).