Titan 2WD V8-5.6L (VK56) (2004)
19. Make sure the seat track mounting tab and the rear stopper are touching (see Figure 8).
20. Measure the distance between the gear box and the mounting tab (see left side of Figure 8).
21. Measure and adjust the other seat track mounting tab to the same distance (see right side of Figure 8).
Figure 9
22. Replace all six rubber grommets with the new ones from the kit 3 on each side (see Figure 9).
23. Put the new worm gears, gear boxes, and drive cable assembly (all as one unit) back into the seat frame and move both seat tracks back into
position on top of the seat track mounting tabs.
Figure 10
CAUTION:
Avoid bending the drive cable. Bending the drive cable will create a noise when the seat is operated.
Figure 11