Titan 2WD V8-5.6L (VK56) (2004)
26.5-35.4 in-lb/ 3.5 +/- 0.5 Nm.
7.
Turn the seat over to access the bottom surface of the U-brackets. Clamp one U- bracket with narrow nose locking pliers so that it flexes and
contacts the synchronization tube as shown in Figure 5.
8.
Using a center punch, mark the spot on the bottom surface of the U-bracket 10 mm/0.39 inch from the each edge and drill an 1/8 inch hole that
passes through the U-bracket and the wall of the synchronization tube (see Figure 6).
9.
Repeat the procedure on the top surface of the U-bracket.
10.
Repeat Steps 7, 8 and 9 on the other end of the synchronization tube.