Titan 2WD V8-5.6L (VK56) (2004)
3.
Make sure the transmission is in Park and the brake pedal is released.
IMPORTANT:
Do not push the brake pedal until step 6.
4.
Start the engine and let it idle.
^
Keep the transmission in Park.
5.
On CONSULT-II, select ABS Data Monitor.
6.
Slowly push the brake pedal approximately 2 inches, then release.
NOTE:
2 inches is approximately half-way between the pedal "see height" and "depressed height".
7.
Repeat step 6 ten times.
^
If DTC C1179 is detected (comes up on CONSULT-II), this bulletin applies; go to Part 2.
^
If DTC C1179 is not detected, go to the next step.
8.
Repeat steps 2 though 7.
^
If you have done steps 2 through 7 twice, and DIG C1179 is not detected, this bulletin does not apply. Go to ASIST for further diagnostic
information.
Part 2
Part 2:
Download special ABS/VDC Reprogramming Data from ASIST onto your standard 8 MB (orange) Reprogramming Card.
This part of the procedure involves two general steps:
^
Setting up
^
Download (transfer) data from ASIST into CONSULT-II (8 MB orange Reprogramming card).
SETTING UP:
1.
Install the standard 8 MB (orange)
Reprogramming Card into CONSULT-II.
Use slot A-top slot (see Figure 1).
CAUTION:
Do NOT use the 16 MB (orange) "QR25 Campaign ECM Software" Card (# J-44200-ECMR-16). If you use this card, it will be reformatted to
an 8 MB card.