Titan 2WD V8-5.6L (VK56) (2004)
NOTE:
Make sure the inboard pads are installed with the wear sensors facing down (towards the ground). See Figure 10.
F.
Reinstall the cylinder body.
NOTE:
If the vehicle you are working on requires new torque members (see Step 5), make sure to use the new sliding pin bolts included in the Torque
Member Kit.
^
First, tighten the Lower sliding pin bolt - farthest from the bleed valve. Then tighten the Upper sliding pin bolt.
Torque Spec: 40 - 44 N-m (4.0 - 4.5 kg-m, 30 - 32 ft-lb)
Step 8
Step 8: Resurface the Rear Brake Rotors and Replace the Rear Brake Pads.
A.
Remove the rear wheels, and brake caliper assemblies.
^
Refer to section BR in the ESM for rear brake caliper assembly removal.