Titan 2WD V8-5.6L (VK56) (2004)
^
New bolts are listed in the Parts Information.
^
Tighten torque member bolts to 210 N-m (21 kg-m, 155 ft-lb).
B.
Install the new brake pad retainers (see Figure 5).
^
Brake pad retainers are included with the brake pad kit.
^
Apply a thin layer of Molykote(R) M77 grease-P/N 44003-7S000-to the pad retainers.
CAUTION:
Don't get grease on the brake rotor friction surface.
C.
Prep the inboard brake pads for installation.
Apply a "moderate amount of Molykote(R) M77 grease-P/N 44003-7S000-to the back of each pad as shown in Figure 6.
NOTE:
^
The inboard pads have a straight edge and pad wear sensor. The inboard backing shims have cut-outs on the edges.
^
Install the shim and push down on it to squeeze out any excess grease.
^
Clean off all of the excess grease that squeezes out (see Figure 7).
CAUTION:
Don't get any grease on the brake pad or brake rotor friction surface.