Titan 2WD V8-5.6L (VK56) (2004)
Wheel Speed Sensor: Service and Repair
ABS
Wheel Sensors
WHEEL SENSORS
Removal and Installation
REMOVAL
1. Remove ABS sensor mounting screw. When removing the front ABS sensor, first remove the disc rotor to gain access to the front ABS sensor
mounting bolt. Refer to "Removal and Installation of Brake Caliper Assembly and Disc Rotor".
2. Pull out the sensor, being careful to turn it as little as possible.
CAUTION:
^
Be careful not to damage sensor edge and sensor rotor teeth.
^
Do not pull on the sensor harness.
3. Disconnect ABS sensor harness electrical connector, then remove harness from mounts.
INSTALLATION
Before installing ABS sensors,
^
Inspect ABS sensor O-ring, replace sensor assembly if damaged.
^
Clean ABS sensor hole and mounting surface with brake cleaner and a lint-free shop rag. Be careful that dirt and debris do not enter the axle.
^
Apply a coat of suitable grease to the ABS sensor O-ring and mounting hole.
Installation is in the reverse order of removal.
Sensor Rotor
SENSOR ROTOR
Removal and Installation
FRONT
NOTE: The wheel sensor rotors are built into the wheel hubs and are not removable. If damaged, replace wheel hub and bearing assembly.
REAR
It is necessary to disassemble the rear axle to replace the sensor rotor.
^
Pull the sensor rotor of off the axle shaft using Tool and a press.
Tool number : 205-DO02
^
Install new sensor rotor on axle shaft using a suitable length steel tube and a press. Make sure sensor rotor is fully seated.
CAUTION: Do not reuse the old sensor rotor.