Titan 2WD V8-5.6L (VK56) (2004)
Wheel Speed Sensor: Service and Repair
Vdc/TCS/ABS
Wheel Sensors
WHEEL SENSORS
Removal and Installation
REMOVAL
1. Remove ABS sensor mounting screw
^
When removing the front ABS sensor, first remove the disc rotor to gain access to the front ABS sensor mounting bolt.
2. Pull out the sensor, being careful to turn it as little as possible
CAUTION:
^
Be careful not to damage sensor edge and sensor rotor teeth.
^
Do not pull on the sensor harness.
3. Disconnect ABS sensor harness electrical connector, then remove harness from mounts
INSTALLATION
Before installing ABS sensors,
^
Inspect ABS sensor O-ring, replace sensor assembly if damaged
^
Clean ABS sensor hole and mounting surface with brake cleaner and a lint-free shop rag Be careful that dirt and debris do not enter the axle
^
Apply a coat of suitable grease to the ABS sensor O-ring and mounting hole
Installation is in the reverse order of removal
Sensor Rotor
SENSOR ROTOR
Removal and Installation
FRONT
NOTE: The wheel sensor rotors are built into the wheel hubs and are not removable If damaged, replace wheel hub and bearing assembly
REAR
It is necessary to disassemble the rear axle to replace the sensor rotor
^
Pull the sensor rotor of off the axle shaft using Tool and a press
Tool number: 205-D002
^
Install new sensor rotor on axle shaft using a suitable length steel tube and a press Make sure sensor rotor is fully seated
CAUTION: Do not reuse the old sensor rotor.