Titan 2WD V8-5.6L (VK56) (2004)
2.
Press SUB MODE (see Figure 4) then:
^
From the listed items, find and select BATTERY CHARGE
3.
Check the CONSULT-II's "Charger Input" reading (see Figure 5).
NOTE:
^
"Battery Voltage" is the voltage level of CONSULT-II's battery.
^
"Charger Input" is the voltage level of the vehicle's battery. (It must be above 12 volts.)
CAUTION:
If the "Charger Input" is below 12 volts:
^
A list of items to check when "Charger Input" voltage is below 12V is contained in the "ECM Reprogramming For Nissan Vehicles" general
procedure.
Step Three:
Reprogram The ECM
Step Four:
ECM Reprogramming "Wrap-up"
1.
Turn the ignition switch "OFF" and CONSULT-II "OFF".
2.
Wait more than 10 seconds, then: