Titan 2WD V8-5.6L (VK56) (2004)
/Page-519002.png)
Undersize
Undersize ........................................................................................................................................................................................ 0.25 mm (0.0098 in.)
Thickness ................................................................................................................................................................ 2.618-2.626 mm (0.1031-0.1034 in.)
Main journal diameter ................................................................................................................... Grind so that bearing clearance is the specified value
Main Bearing Oil Clearance
Main bearing oil clearance
No 1 and 5
Standard ................................................................................................................................................... 0.001-0.011 mm (0.00004 - 0.0004 in)
Limit ................................................................................................................................................................................... 0.021 mm (0.0008in )
No 2, 3 and 4
Standard ....................................................................................................................................................... 0.007-0.017 mm (0.0003-0.0007 in)
Limit ................................................................................................................................................................................... 0.027 mm (0.0011 in)
Main Bearing Caps
Follow the steps below to tighten each main bearing cap bolts.
a. Apply engine oil to threads and seating surface of bolts, and tighten all bolts temporarily
Main bearing cap bolts in order of 1 to 10: 39.2 Nm (4.0 kg-m, 29 ft. lbs.)
Main bearing cap sub bolt in order of 11 to 20: 29.4 Nm (3.0 kg-m, 22 ft. lbs.)
Main bearing cap bolts in order of 1 to 10: 40°
CAUTION: Measure tighten angle in step "d" and "e" with angle wrench (SST). Do not measure visually.
Main bearing cap sub bolt in order of 11 to 20: 30°
Side bolt to in order of 21 to 30: 49 Nm (5.0 kg-m, 36 ft. lbs.)
^
Rotate crankshaft by hands after bolts are tightened. Check if it rotates smoothly.
