Titan 2WD V8-5.6L (VK56) (2004)
Crankshaft Main Bearing Seal: Service and Repair
Removal and Installation of Rear Oil Seal
REMOVAL
1. Remove transmission assembly.
a. Remove drive plate.
^
Holding crankshaft pulley mounting bolts, lock crankshaft to remove drive plate bolts.
^
Remove the bolts diagonally.
CAUTION:
^
Be careful not to damage drive plate. Especially, avoid deforming and damaging of signal plate teeth (circumference position).
^
Place the drive plate with signal plate surface facing other than downward.
^
Keep magnetic materials away from signal plate.
b. Remove engine rear plate.
2. Remove the rear oil seal using a suitable tool.
CAUTION: Be careful not to damage crankshaft and oil seal retainer surface.
INSTALLATION
1. Install the rear oil seal to oil seal retainer using a suitable tool.
^
Tap until flattened with front edge of oil seal retainer Do not damage or scratch outer circumference of rear oil seal.