Titan 2WD V8-5.6L (VK56) (2004)
Water Pump: Service and Repair
WATER PUMP
Water Pump
Removal and Installation
CAUTION:
^
When removing water pump, be careful not to get engine coolant on drive belt.
^
Water pump can not be disassembled and should be replaced as a unit.
REMOVAL
1. Drain engine coolant so that no engine coolant comes out from water pump fitting hole.
CAUTION: Perform when the engine is cold.
2. Remove following parts.
^
Engine front undercover using power tool.
^
Air duct (inlet).
^
Drive belt.
CAUTION: Leave auto tensioner pulley in its fixed position when removing drive belt.
3. Remove water pump pulley
4. Remove water pump.
^
Engine coolant will leak from the cylinder block, so have a receptacle ready below.
CAUTION: Handle water pump vane so that it does not contact any other parts.
INSPECTION AFTER REMOVAL