Titan 2WD V8-5.6L (VK56) (2004)
/Page-1809012.png)
19.
Place the washer and "push nut" (included with the kit) onto the right-side door pin, as shown in Figure 12).
20.
Re-install the link assembly cover.
21.
Re-install the actuator.
22.
Re-connect the wire harness to the actuator.
23.
Re-connect the wire harnesses to the amplifier.
24.
Re-install the audio amplifier.
25.
Re-attach the gas pedal assembly.
26.
Re-install the BCM.
27.
Re-connect the negative battery terminal.
28.
Turn the ignition key to "ON".
29.
Use the HVAC controls to cycle through the face level, defrost, and floor modes of the HVAC system:
^
to make sure the actuator works and,
^
the doors are "engaged" and working properly.
30.
Re-connect the wire harnesses to the BCM.
31.
Re-install the instrument lower cover and the lower instrument panel.
32.
Re-attach the driver's seat.
33.
Reprogram radio presets.
