Titan 2WD V8-5.6L (VK56) (2004)
Figure C-16
11. Install the condenser fan mounting bolt.
12. Install and torque 2 nuts to the air bag sensor.
-
Torque: 15 N.m (1.52 Kg-m, 11 ft-lb)
-
Apply medium strength thread-locker to the studs (Nissan P/N 999MP-AM005P or equivalent).
13. Make sure the Rubber Seal is inside the condenser fan electrical connector and then connect the connector.
14. Install the bumper as follows:
For Titan and Armada with steel bumper do the following:
a. Lift bumper ON the locating tabs; both sides (see Figure C-18).