Titan 2WD V8-5.6L (VK56) (2004)
Figure D-4
3. Install Protector 1 around the fan harness:
-
Wrap / roll the protector tightly around the harness.
-
While holding the protector rolled tightly, remove the adhesive backing and secure the protector.
NOTE:
The protector should slide on the harness.
Figure D-5
4. Remove the adhesive backing from Protector 2 and install it around protector 1:
-
Fingers / slits on protector 2 must be facing the fan motor.
-
Align the bottom of protector 2 fingers with the end of protector 1.