Titan 2WD V8-5.6L (VK56) (2004)
Figure D-11
9. Press and smooth all parts of protector 3. Make sure it is completely stuck to the fan motor.
-
Pay special attention to the area shown in Figure D-11. Make sure there is good adhesion in this area.
NOTE:
The large support ribs on the fan shroud are labeled 1 o'clock, 5 o'clock, 7 o'clock, and 11 o'clock for reference when installing parts on to
the fan shroud.
10. Thoroughly clean all dirt and debris from the fan shroud between the 1 o'clock and 5 o'clock ribs (see Figure D-12).
-
Use a locally approved brake cleaner and a clean rag.
11. Install Protector 4 on the fan shroud.
a. Remove 1 of the 4 sections from protector 4 adhesive backing.
b. Stick the 1st section next to the 5 o'clock support rib.