Titan 2WD V8-5.6L (VK56) (2004)
Figure B-1
-
If the wires are damaged (cracked or missing insulation), STOP; no more testing is needed. Go to Procedure C and replace the condenser fan
assembly.
2. Disconnect the condenser fan electrical connector.
IMPORTANT:
Do not lose the rubber seal from inside the connector.
3. Shake the bottle of reflective paint and open an applicator.
-
Reflective paint and applicator are included with special tool kit J-49489.
-
Additional reflective paint and applicators can be ordered from TECH-MATE.
Figure B-2
4. Paint a "dime sized" area on the outer portion of one fan blade.
-
Make sure the painted area is completely filled in (no unpainted spots or thin paint in the dime sized area).
-
Allow the paint to dry-about 5 minutes