Titan 2WD V8-5.6L (VK56) (2004)
Tire Pressure Module: Testing and Inspection
Transmitter ID Registration Procedure
With Transmitter Activation Tool
ID REGISTRATION WITH TRANSMITTER ACTIVATION TOOL
This procedure must be done after replacement of a low tire pressure warning transmitter, BCM or tire rotation.
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected during self-diagnosis
depending on control unit which carry out CAN communication.
1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch
ON.
2. Select "START (NISSAN BASED VHCL)".
3. Touch "BCM" on "SELECT SYSTEM" screen.
NOTE: If "BCM" is not indicated, go to "CONSULT-II Data Link Connector (DLC) Circuit".
4. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
5. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
6. With the transmitter activation tool (J-45295) pushed against the front left transmitter position of the tire air valve, press the button
Tool number - (J45295)
7. Register the IDs in order from FR LH, FR RH, RR RH, and RR LH. When ID registration of each wheel has been completed, a buzzer sounds and
the warning lamp flashes.
8. After completing all ID registrations, press "END" to complete the procedure.
NOTE: Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function
properly.
Without Transmitter Activation Tool
ID REGISTRATION WITHOUT TRANSMITTER ACTIVATION TOOL
This procedure must be done after replacement of a low tire pressure warning transmitter, BCM, or tire rotation.
1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch
ON.