Titan 2WD V8-5.6L (VK56) (2004)
16.
Attach the new body clip to the body.
Final Quality Check
17.
Check the air bag light operation as follows:
a.
Turn the ignition ON.
b.
Look at the air bag light.
c.
Make sure the air bag warning light comes on for 7 seconds and then goes out.
Harness Replacement Part 1 (Includes Seat Belt Replacement, If Needed)
NOTE:
^
There are several model variations (power seats, audio, side air bag, navigation, etc). Due to these variations the harness removal photos in this
procedure may not have the exact interior trim, connectors, and harness mounting locations as the vehicle you are working on.
^
It is recommended that you mark the harness mounting location during disassembly.
Floor and Rear Door (Left and/or Right Side)
^
This portion of the procedure is for the sections of the harness that are on the floor of the vehicle (under the carpet) and inside the rear door.
^
The photos in this portion of the procedure are of the left side (driver side). If you are working on the right side (passenger side) the photos are a
mirror image.
1.
Write down the radio station presets.
2.
If equipped with power seats; move the seats to the "mid-point" position (half-way between full forward and full rearward).
3.
Put the gear selector in the Neutral position.
4.
Disconnect both battery cables-negative cable first.
5.
Remove the front seat.
a.
Remove the 4 seat mounting bolts.
b.
Disconnect all of the seat electrical connectors.