Titan 2WD V8-5.6L (VK56) (2004)
10.
Secure the new BCM Sub-Harness to the Existing Vehicle Harness (see Figure 9).
^
Use the Tie Wrap that comes already attached to the new Sub-Harness.
11.
Re-connect the negative battery cable.
12.
Confirm the installed BCM Sub-Harness does not interfere with the operation of the adjustable pedal assembly.
NOTE:
It is okay if the BCM Sub-Harness has slight contact with the adjustable pedal assembly when the pedal assembly is adjusted to the end of its
upward travel (closest to the driver).
13.
For vehicles without a trailer lights wiring connector, confirm BCM operation as follows:
a.
Turn the ignition switch ON.
b.
Place your hand on the new BCM Sub-Harness.
c.
Activate the left turn indicator (blinker) and confirm a "click" is felt / heard each time the left turn indicator light flashes.
d.
Activate the right turn indicator (blinker) and confirm a "click" is felt / heard each time the right turn indicator light flashes.
e.
Apply the brake pedal and confirm a "click" is felt / heard when the brake lights come on.
^
If you feel / hear a "clicking" noise when performing steps c, d, and e, go to the next step.
^
If you do not feel / hear a "clicking" noise when performing steps c, d, and e, replace the BCM, then go to the next step.
14.
Re-install all components in reverse order of removal.
15.
Re-program all radio station presets.
16.
If the BCM was replaced, you'll need to do the following:
IMPORTANT:
You MUST perform the following steps according to the applicable service manual to ensure the new BCM is properly programmed to the original
vehicle settings.
^
BCM "Write Configuration" using CONSULT-II. Refer to "WRITE CONFIGURATION PROCEDURE" in section "BCS" of the applicable
service manual.
^
Initialization of NATS System and Registration of all NATS Ignition Key I.D.s. Refer to Nissan Technical Bulletin NTB03-031b.
^
I.D. Registration Procedure of the Low Tire Pressure Warning System. Refer to "I.D. REGISTRATION PROCEDURE" in section "WT" of the
applicable service manual.
^
Register I.D. Code for Remote Keyless Entry Keyfobs. Refer to section "BL" of the applicable service manual.