Titan 2WD V8-5.6L (VK56) (2004)
^
Reconnect the RH connector ONLY (as viewed in Figure 15.)
9.
If the BCM does not need to be replaced:
^
Install the new Sub-Harness.
^
Start by disconnecting ONLY the two horizontal Connectors at the BCM (see Figure 15).
12.
Secure the new BCM Sub-Harness by snapping the Attachment Clip into the Instrument Panel Bracket Hole (see Figure 18).
13.
Re-connect the negative battery cable.
14.
For vehicles without a trailer lights wiring connector, confirm BCM operation as follows:
a.
Turn the ignition switch ON.
b.
Place your hand on the new BCM Sub-Harness.
c.
Activate the left turn indicator (blinker) and confirm a "click" is felt / heard each time the left turn indicator light flashes.
d.
Activate the right turn indicator (blinker) and confirm a click" is felt / heard each time the right turn indicator light flashes.
e.
Apply the brake pedal and confirm a click" is felt / heard when the brake lights come on.
^
If you feel / hear a clicking" noise when performing steps c, d, and e, go to the next step.
^
If you do not feel / hear a clicking" noise when performing steps c, d, and e, replace the BCM, then go to the next step.
15.
Re-install all components in reverse order of removal.
16.
Re-program all radio station presets.
17.
If the BCM was replaced, you'll need to do the following:
IMPORTANT:
You MUST perform the following steps according to the applicable service manual to ensure the new BCM is properly programmed to the original
vehicle settings.
^
BCM "Write Configuration" using CONSULT-II. Refer to WRITE CONFIGURATION PROCEDURE" in section BCS" of the applicable
service manual.
^
Initialization of NATS System and Registration of all NATS Ignition Key I.D.s. Refer to Nissan Technical Bulletin NTB03-031b.
^
I.D. Registration Procedure of the Low Tire Pressure Warning System. Refer to I.D. REGISTRATION PROCEDURE" in section "WT" of the
applicable service manual.
^
Register I.D. Code for Remote Keyless Entry Keyfobs. Refer to section "BL" of the applicable service manual.
^
BCM Headlamp Configuration. Refer to "HEADLAMP" information in section "LT" of the applicable service manual.