Titan 2WD V8-5.6L (VK56) (2004)
3.
Check the CONSULT-II's "Charger Input" reading (see Figure D).
NOTE:
^
"Battery Voltage" is the voltage level of CONSULT-II's battery.
^
"Charger Input" is the voltage level of the vehicle's battery. (It must be above 12 volts.)
Step Three: Reprogram the TCM
Step Four: TCM Reprogramming "Wrap-up"
1.
Turn the ignition and CONSULT-II OFF.
2.
Disconnect CONSULT-II from the vehicle.
3.
Start the Engine and make sure the MIL is OFF.
^
If it's still ON, use CONSULT-II with the Diagnostic (red/white) Card to erase any DTC that may have stored in the TCM and/or the ECM
during the reprogramming procedure.
4.
Test-drive the vehicle and make sure the transmission operates correctly in all modes. See the AT section of the appropriate Service Manual for
operation specifications.