Titan 2WD V8-5.6L (VK56) (2004)
Impact Sensor: Service and Repair
Crash Zone Sensor
CRASH ZONE SENSOR
Removal and Installation
REMOVAL
CAUTION:
-
Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
1. Remove front grille.
2. Disconnect the crash zone sensor harness connector.
3. Remove crash zone sensor nuts.
CAUTION:
-
Replace crash zone sensor if it has been dropped or sustained an impact.
-
Do not disassemble crash zone sensor.
INSTALLATION
To install, reverse the removal procedure.
-
After the work is complete, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS Operation Check".