Titan 2WD V8-5.6L (VK56) (2004)
Impact Sensor: Service and Repair
Side Air Bag (Satellite Sensor)
SIDE AIR BAG (SATELLITE) SENSOR
Removal and Installation
REMOVAL
CAUTION:
-
Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
1. Remove seat belt pre-tensioner.
2. Remove side air bag (satellite) sensor nuts.
3. Disconnect the side air bag (satellite) sensor harness connector.
CAUTION:
-
Do not use old nuts after removal; replace with new nuts.
-
Check side air bag (satellite) sensor to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it with
new one.
-
Do not disassemble side air bag (satellite) sensor.
-
Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.
INSTALLATION
To install, reverse the removal procedure.
-
After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS Operation Check".