Titan 2WD V8-5.6L (VK56) (2004)
Seat Belt Retractor: Service and Repair
Crew Cab
SEAT BELT
REMOVAL OF SEAT BELT RETRACTOR
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
1. Remove the center pillar upper/lower finishers.
2. Remove the seat belt retractor anchor bolts and assembly.
-
On RH side, disconnect the seat belt tension sensor.
3. Disconnect the seat belt pre-tensioner electrical connector.
CAUTION:
-
For installing/removing seat belt pre-tensioner connector, insert a thin screwdriver wrapped in tape into the notch, lift the lock and remove the
connector.
-
Install the connector with the lock raised, and push the lock into the connector.
INSTALLATION OF SEAT BELT RETRACTOR
Installation is in the reverse order of removal.
-
Install the seat belt retractor upper bolt first.