Titan 2WD V8-5.6L (VK56) (2004)
CAUTION:
Don't damage the trim or the seat material during removal.
4.
On the back side of the switch trim, scuff around the outer edge using a 3M scotch-Bright(TM) pad or equivalent.
^
Remove any sharp edges.
^
Rough-up any smooth surfaces that touch the seat material.
5.
Re-install the trim and buttons on the power seat switch. Make sure the 4 trim locking tabs snap (lock) into place.
Apply Dupont Krytox(R) Lubricant GPL-105 (or equivalent) to the Lower Edge of the Seat Material and Around the Outer Edge of the Power Seat
Switch Trim.