Titan 2WD V8-5.6L (VK56) (2004)
^
Un-tape the connectors that are needed. Leave the connectors you don't need taped to the harness.
46.
Connect both battery cables-positive cable first.
47.
Reset the radio station presets.
48.
If Inspection Procedure 1 was NG, or Inspection Procedure 2 result was "light stays on or blinks"; connect CONSULT-II and clear codes from the
Air Bag Control Unit SELF-DIAG [PAST].
Final Quality Checks
49.
Check the air bag light operation as follows:
a.
Turn the ignition OFF and then ON.
b.
Observe the air bag warning light.
c.
Make sure the air bag warning light comes on for 7 seconds and then goes out.
50.
Confirm that all systems related to the harness replacement are functioning correctly.
High Mount Stop Lamp Harness Branch (Passenger Side-Right Side-Only)
51.
Remove the rear seat belt D-ring covers and bolts-left and right side.