Titan 2WD V8-5.6L (VK56) (2004)
13.
First, tape the door grommet to the corrugated tube, then
14.
Wrap the entire length of the corrugated tube with vinyl tape.
^
As you wrap, keep the tape tight and the tape roll close to the harness.
^
Over-lap the tape 50% as you wrap.
^
Make sure to wrap around the clips (diaper wrap) so they will not move-the clips must stay in position.
^
Make sure to cover the area on the body side between the corrugated tube and the vinyl tube.
^
Double wrap the entire length; one layer left to right and another layer right to left.
15.
Attach the new hinge rod clip below the bracket as shown in Figure B9.