Titan 2WD V8-5.6L (VK56) (2004)
/Page-1806003.png)
7. Secure the axle shaft in a suitable vise, then use a 1/4 in size drill bit to drill a hole approximately 3/4 into the thickness of the bearing ring retainer
[3/4 thickness is approximately 6.3 mm (0.25 inch) deep].
CAUTION:
^
Mount the axle shaft using a soft jaw vise to avoid damaging the axle shaft.
^
Do not drill all the way through the bearing ring retainer, the drill may damage the axle shaft surface.
8. Strike the bearing ring retainer using a suitable chisel and hammer with the chisel positioned across the drilled hole. Break the bearing ring retainer
to remove it.
CAUTION: Do not heat or cut the axle shaft bearing or bearing ring retainer with a torch during removal, doing so will damage the axle shaft.
9. Pull the axle shaft bearing off of the axle shaft using Tool.
Tool number: 205-D002
CAUTION: Do not heat or cut the axle shaft bearing or bearing ring retainer with a torch during removal, doing so will damage the axle shaft.
10. Remove the axle oil seal and discard.
CAUTION: Do not reuse the axle oil seal. The axle oil seal must be replaced every time the axle shaft assembly is removed from the axle shaft
housing.
11. Remove the wheel bearing cage.
NOTE:
