Titan 2WD V8-5.6L (VK56) (2004)
Fluid - A/T: Testing and Inspection
Checking A/T Fluid
1. Warm up the engine.
2. Check for any fluid leaks.
3. Remove the tightening bolt for the ATF level gauge.
4. Before driving, the fluid level can be checked at fluid temperatures of 30° to 50°C (86° to 122°F) using the "COLD" range on the ATF level
gauge as follows:
a. Park the vehicle on a level surface and set the parking brake.
b. Start the engine and move the selector lever through each gear position. Shift the selector lever into the "P" position.
c. Check the fluid level with the engine idling.
d. Remove the ATF level gauge and wipe it clean with a lint-free paper
CAUTION: When wiping the fluid from the ATF level gauge, always use a lint-free paper, not a cloth.
e. Re-insert the ATF level gauge into the charging pipe until the cap contacts the top of the charging pipe as shown.
CAUTION: To check fluid level, insert the ATF level gauge until the cap contacts the top of the charging pipe, with the gauge reversed from
the normal inserted position.
f.
Remove the ATF level gauge and note the fluid level. If the fluid level is at low side of range, add fluid to the transmission through the
charging pipe.
CAUTION: Do not overfill the transmission with fluid.
5. Drive vehicle for approximately 5 minutes in urban areas.