Titan 2WD V8-5.6L (VK56) (2004)
/Page-1345002.png)
PARTS INFORMATION
Claims Information
Additional Procedure Information: (Applies ONLY to early type cooler lines)
IMPORTANT:
You must remove all 4 hose clamps that come installed on the cooler lines and discard them. You must use (install) the new hose clamps that are listed in
the Parts Information.
^ Throughly clean the metal tubes before installing the new cooler lines. Remove any ATF or other debris.
^ Install the cooler line rubber hoses on the metal tubes as shown in Figure 2.
