Titan 2WD V8-5.6L (VK56DE) (2006)
Hose/Line HVAC: Service and Repair
Manual Air Conditioner
Low-Pressure Flexible Hose
Removal and Installation for Low-pressure Flexible Hose
REMOVAL
1. Remove the engine room cover using power tool.
2. Remove the engine air cleaner and air ducts.
3. Discharge the refrigerant. Refer to "HFC-134a (R-134a) Service Procedure".
CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
4. Remove the low-pressure flexible hose.
INSTALLATION
Installation is in the reverse order of removal. Refer to "Components".
CAUTION:
-
Replace the O-ring of the low-pressure flexible hose with a new one, then apply compressor oil to it when installing it.
-
After charging refrigerant, check for leaks.
High-Pressure Flexible Hose
Removal and Installation for High-pressure Flexible Hose
REMOVAL
1. Remove the engine under cover using power tool.
2. Remove the engine air cleaner and air ducts.
3. Discharge the refrigerant. Refer to "HFC-134a (R-134a) Service Procedure".
4. Remove the high-pressure flexible hose.
CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
INSTALLATION
Installation is in the reverse order of removal. Refer to "Components".
CAUTION:
-
Replace the O-ring of the high-pressure flexible hose with a new one, then apply compressor oil to it when installing it.
-
After charging refrigerant, check for leaks.
High-Pressure Pipe
Removal and Installation for High-pressure Pipe
REMOVAL
1. Disconnect the battery negative terminal and battery positive terminal.
2. Reposition the IPDM E/R aside.
3. Remove the front right wheel and tire assembly. Refer to "Rotation".
4. Position aside the front floor insulator.
5. Discharge the refrigerant. Refer to "HFC-134a (R-134a) Service Procedure".
6. Remove the low pressure pipe.
7. Remove the high-pressure pipe.
CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
INSTALLATION
Installation is in the reverse order of removal. Refer to "Components".
CAUTION:
-
Replace the O-ring of the high-pressure pipe with a new one, then apply compressor oil to it when installing it.
-
After charging refrigerant, check for leaks.
Low-Pressure Pipe
Removal and Installation for Low-pressure Pipe