Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Rear Door Window Regulator: Service and Repair
REAR DOOR GLASS AND REGULATOR
Rear Door Glass Regulator Assembly
REMOVAL
1. Remove the rear door finisher. Refer to See: Front Door/Front Door Panel/Service and Repair.
2. Operate the power window switch to raise/lower the door window until the glass bolts can be seen.
3. Remove the inside seal.
4. Remove the glass bolts, raise the glass and hold in place with suitable tool.
5. Remove the bolts and the regulator and guide channel from the panel.
6. Disconnect the connector for the regulator assembly.
INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
-
Gear wear
-
Regulator deformation
-
Spring damage
-
Grease condition for each sliding part
INSTALLATION
Installation is in the reverse order of removal.