Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
REAR WHEEL SENSOR ROTOR
Removal
Remove the rear axle shaft assembly. Refer to See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Rear Axle Shaft.
NOTE:
It is necessary to disassemble the rear axle shaft assembly to replace the rear wheel sensor rotor.
Installation
Installation is in the reverse order of removal.
CAUTION:
-
Do not reuse the old rear wheel sensor rotor.
-
Do not reuse the rear axle oil seal. The rear axle oil seal must be replaced every time the rear axle shaft assembly is removed from the
rear axle shaft housing.