Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Radiator Cooling Fan: Service and Repair
Removal And Installation
ENGINE COOLING FAN
Removal and Installation (Crankshaft Driven Type)
REMOVAL
1. Remove the air duct and resonator assembly. Refer to See: Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair/Removal and Installation.
2. Remove the engine front undercover using power tool.
3. Remove the lower radiator shroud. Refer to See: Radiator/Service and Repair/Removal and Installation.
4. Remove the drive belt. Refer to See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair.
5. Remove the cooling fan.
INSPECTION AFTER REMOVAL
Fan Coupling
Inspect fan coupling for oil leakage and bimetal conditions.
Fan Bracket
-
Visually check that there is no significant looseness in the fan bracket shaft, and that it turns smoothly by hand.
-
If there are any unusual concerns, replace the cooling fan pulley.
INSTALLATION
Installation is in the reverse order of removal.
-
Install cooling fan with its front mark "F" facing front of engine. Refer to "Removal and Installation (Crankshaft Driven Type)".
INSPECTION AFTER INSTALLATION
-
Check for leaks of the engine coolant. Refer to See: Coolant/Testing and Inspection.
-
Start and warm up the engine. Visually make sure that there are no leaks of the engine coolant.