Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
f. Use the new tie-wrap to secure all the wires to the black corrugated tubing (see Figure 6).
^
New tie-wrap is included with the new sender unit.
^
Make sure all wires are tied together (3 fuel level sending unit wires and 2 fuel pump wires).
^
Place the Tie-Wrap 90 mm (about 3.5 inches) from the top of the tubing.
^
Make sure the wires do not interfere with the movement of the float arm.
4. Carefully reinstall the Fuel Pump Assembly back into the vehicle in reverse of removal.
^ IMPORTANT: Use a new seal (O-Ring) when reinstalling the Fuel Pump Assembly.
^ Refer to the Service Manual as needed.
CAUTION:
DO NOT bend the Float Arm when reinstalling the Fuel Pump.
5. Confirm the Fuel Gauge operates properly.