Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
B. Compare the Part Number you wrote down to the numbers in the Current ECM Part Number column in Table A , or Table B above.
^
If there is a match, this bulletin applies. Continue with the reprogramming procedure.
NOTE:
If there are two lines (two reprogramming options) on your C-III screen, use the one that does not have the message "Caution! Use ONLY with
NTBXX-XXX".
^
If there is not a match, this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.
3. If this bulletin applies and you have performed ECM reprogramming, the screen in Figure 2 appears when reprogramming is complete.
4. Make sure to erase DTCs from all systems.
NOTE:
During reprogramming, DTCs will set in several systems and must be erased.
5. Test drive the vehicle and make sure it operates correctly and the Check Engine light is OFF.
^ If the Check Engine light comes ON, go back to ASIST for further diagnostic information. Refer to the applicable Electronic Service Manual as
needed.
^ Diagnosis and repairs beyond ECM reprogramming are not covered by this bulletin.