Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Body Control Module: Service and Repair
BCM (BODY CONTROL MODULE)
Removal and Installation
BCM
Removal
NOTE:
If possible, before removing BCM, retrieve current BCM configuration to use for reference when configuring brand-new BCM after installation. Refer
to See: Body and Frame/Body Control Systems/Testing and Inspection/Programming and Relearning/Configuration/Special Repair Requirement.
1. Disconnect the battery negative terminal.
2. Remove the lower knee protector. Refer to See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Instrument Panel Assembly/Removal And Installation.
3. Remove the screw and release the BCM.
4. Disconnect the connectors and then remove the BCM.
Installation
Installation is in the reverse order of removal.
NOTE:
-
When replacing BCM, it must be configured. Refer to See: Body and Frame/Body Control Systems/Testing and Inspection/Programming and
Relearning/Configuration/Special Repair Requirement.
-
When replacing BCM, perform initialization of NATS system and registration of all NATS ignition key IDs. Refer to See: Accessories and
Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Additional Service When Replacing
Control Unit See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/ECM
Re-Communicating Function See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and
Relearning/ECM Re-Communicating Function.
-
When replacing BCM, perform ID registration procedure of low tire pressure warning system. Refer to See: Instrument Panel, Gauges and
Warning Indicators/Tire Monitoring System/Testing and Inspection/Programming and Relearning/ID Registration Procedure.