Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Engine Control Module: Programming and Relearning
Procedure After Replacing ECM
INSPECTION AND ADJUSTMENT
Procedure After Replacing ECM
When replacing ECM, the following procedure must be performed.
1. Perform initialization of NVIS (NATS) system and registration of all NVIS (NATS) ignition key IDs. Refer to See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/ECM Re-Communicating Function.
2. Perform See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/VIN Registration.
3. Perform See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Accelerator Pedal
Released Position Learning.
4. Perform See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Throttle Valve
Closed Position Learning.
5. <Flexible Fuel Vehicle>
Perform See: Powertrain Management/Fuel Delivery and Air Induction/Testing and Inspection/Programming and Relearning.
6. Perform See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Idle Air Volume
Learning.
VIN Registration
INSPECTION AND ADJUSTMENT
VIN Registration
DESCRIPTION
VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced.
NOTE:
Accurate VIN which is registered in ECM may be required for Inspection and Maintenance (I/M).
OPERATION PROCEDURE
With CONSULT-III
1. Check the VIN of the vehicle and note it. Refer to See: Application and ID/Identification Number.
2. Turn ignition switch ON and engine stopped.
3. Select "VIN REGISTRATION" in "WORK SUPPORT" mode.
4. Follow the instruction of CONSULT-III display.