Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Air Bag: Service and Repair
Driver Air Bag Module
DRIVER AIR BAG MODULE
Removal and Installation
REMOVAL
CAUTION:
-
Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a driver air bag direct-connect harness
connector is damaged, the spiral cable must be replaced.
-
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least
3 minutes.
-
When servicing the SRS, do not work from directly in front of air bag module.
1. Remove the left and right side bolts.
2. Lift the driver air bag module from the steering wheel.
3. Disconnect the air bag harness and horn connectors, then remove the driver air bag module.
-
For removal/installation of the direct-connect SRS connectors, refer to See: Service and Repair, "Direct-connect SRS Component Connectors".
CAUTION:
-
When servicing the SRS, do not work from directly in front of air bag module.
-
Always place air bag module with pad side facing upward.
-
Do not insert any foreign objects (screwdriver, etc.) into air bag module or harness connectors.
-
Do not disassemble air bag module.
-
Do not use old bolts after removal; replace with new bolts.
-
Do not expose the air bag module to temperatures exceeding 90°C (194°F).
-
Replace the air bag module if it has been dropped or sustained an impact.