Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Wheel Speed Sensor: Service and Repair
VDC/TCS/ABS
Wheel Sensors
WHEEL SENSORS
Removal and Installation
REMOVAL
1. Remove wheel sensor bolt.
-
When removing the front wheel sensor, first remove the disc rotor to gain access to the front wheel sensor bolt. Refer to See: Brakes and Traction
Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Front.
2. Pull out the sensor, being careful to turn it as little as possible.
CAUTION:
-
Be careful not to damage sensor edge and sensor rotor teeth.
-
Do not pull on the sensor harness.
3. Disconnect wheel sensor harness electrical connector, then remove harness from attaching points.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Inspect wheel sensor O-ring, replace sensor assembly if damaged.
-
Clean wheel sensor hole and mounting surface with brake cleaner and a lint-free shop rag. Be careful that dirt and debris do not enter
the axle.
-
Apply a coat of suitable grease to the wheel sensor O-ring and mounting hole.
Sensor Rotor
SENSOR ROTOR
Removal and Installation
FRONT WHEEL SENSOR ROTOR
Removal and Installation
The front wheel sensor rotor is built into the front wheel hub and bearing assembly and is not removable. If damaged, replace the front wheel hub and
bearing assembly. Refer to See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair.
REAR WHEEL SENSOR ROTOR