Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Front Steering Knuckle: Service and Repair
KNUCKLE
Removal and Installation
REMOVAL
1. Remove wheel hub and bearing assembly. Refer to See: Suspension/Wheel Hub/Service and Repair .
-
Disconnect wheel sensor harness connector. Do not remove wheel sensor from wheel hub and bearing assembly for this procedure.
2. Remove steering outer socket from steering knuckle using Tool.
CAUTION:
-
Be careful not to damage ball joint boot.
-
Temporarily tighten nut to prevent damage to threads and to prevent Tool from coming off.
Tool number : HT72520000 (J-25730-A)
3. Remove the coil spring and shock absorber assembly using power tool. Refer to See: Suspension/Suspension Strut / Shock Absorber/Service and
Repair/Removal and Replacement/Front Coil Spring And Strut .
4. Support lower link using a suitable jack.
5. Remove cotter pin and nut from upper link ball joint and discard the cotter pin.