Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Seals and Gaskets: Service and Repair
REAR OIL SEAL
Rear Oil Seal
REMOVAL AND INSTALLATION
Removal
1. Remove rear propeller shaft. Refer to See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement/Propeller Shaft 2S1410.
2. Remove transfer from transmission (4WD models). Refer to See: Service and Repair/Removal and Replacement/Transmission Assembly.
3. Remove rear oil seal using suitable tool.
CAUTION:
Do not scratch rear extension assembly (2WD models) or adapter case assembly (4WD models).
Installation
1. Install new rear oil seal until it is flush into the rear extension case (2WD models) using Tool or adapter case (4WD models) using suitable tool.
Tool number : ST33400001 (J-26082)
CAUTION:
-
Apply ATF to rear oil seal.
-
Do not reuse rear oil seal.
2. Install transfer to transmission (4WD models). Refer to See: Service and Repair/Removal and Replacement/Transmission Assembly.
3. Install rear propeller shaft. Refer to See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement/Propeller Shaft 2S1410.