Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Switch: Service and Repair
DIFFERENTIAL LOCK POSITION SWITCH
Removal and Installation
REMOVAL
Differential Lock Position Switch
CAUTION:
-
Be careful not to damage spline, companion flange and front oil seal when removing propeller shaft.
-
Before removing rear final drive assembly or rear axle assembly, disconnect ABS sensor harness connector from the assembly and move
it away from rear final drive assembly/rear axle assembly area. Failure to do so may result in sensor wires being damaged and sensor
becoming inoperative.
1. Drain rear final drive gear oil. Refer to See: Differential Assembly/Fluid - Differential/Service and Repair/Rear Final Drive M226 (ELD).
2. Remove rear propeller shaft. Refer to See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement/Propeller Shaft 3S1410.
3. Remove both RH and LH axle shafts. Refer to See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Rear Axle Shaft.
4. Remove the carrier cover. Refer to See: Differential Assembly/Differential Cover/Service and Repair/Rear Final Drive M226 (ELD).
5. Remove differential lock solenoid connector (B) bolt and disconnect differential lock position connector (A).
Arrow Indicates Front
6. For installation, apply a paint matching mark on one side of side bearing cap.
CAUTION:
-
Side bearing caps are line-board for initial assembly. The matching marks are used to install them in their original positions.
-
For matching mark, use paint. Do not damage side bearing cap.
7. Remove adjuster lock plates.