Titan 4WD V8-5.6L (VK56DE) (2006)
Brake Hose/Line: Service and Repair
Rear
Removal and Installation of Rear Brake Piping and Brake Hose
REMOVAL
1. Drain brake fluid.
2. Using a flare nut wrench, remove brake tube from brake hose.
3. Remove lock plate and brake hose from bracket.
4. Remove brake hose from cylinder body.
INSTALLATION
1. Install brake hose (1) and new copper washer to cylinder body and tighten to specification.
^
(2): Bolt
^
(3): Rear cylinder body
NOTE: Do not reuse copper washer.
2. Insert brake hose end through bracket, then secure it to bracket with lock plate.
3. Install brake tube to brake hose, then tighten the flare nut using a flare nut wrench.
4. Refill brake fluid and bleed air.