Titan 4WD V8-5.6L (VK56DE) (2006)
Wheel Speed Sensor: Service and Repair
VDC/TCS/ABS
Wheel Sensors
WHEEL SENSORS
REMOVAL
1. Remove wheel sensor bolt.
^
When removing the front wheel sensor, first remove the disc rotor to gain access to the front wheel sensor bolt.
2. Pull out the sensor, being careful to turn it as little as possible.
CAUTION:
^
Be careful not to damage sensor edge and sensor rotor teeth.
^
Do not pull on the sensor harness.
3. Disconnect wheel sensor harness electrical connector, then remove harness from mounts.
INSTALLATION
Installation is in the reverse order of removal. Tighten wheel sensor bolt to specification.
CAUTION: Installation should be performed while paying attention to the following:
^
Inspect wheel sensor O-ring, replace sensor assembly if damaged.
^
Clean wheel sensor hole and mounting surface with brake cleaner and a lint-free shop rag. Be careful that dirt and debris do not enter the axle.
^
Apply a coat of suitable grease to the wheel sensor O-ring and mounting hole.
Sensor Rotor
SENSOR ROTOR
Removal and Installation
FRONT
The wheel sensor rotors are built into the wheel hubs and are not removable. If damaged, replace wheel hub and bearing assembly.
REAR
Removal
1. Remove axle shaft assembly.
NOTE: It is necessary to disassemble the rear axle to replace the sensor rotor.
2. Pull the sensor rotor off the axle shaft using Tool and a press.
Tool number: ST30031000 ( - )
Installation
1. Install new sensor rotor on axle shaft using a suitable length steel tube and a press. Make sure sensor rotor is fully seated.