Titan 4WD V8-5.6L (VK56DE) (2006)
REMOVAL
1. Discharge the refrigerant. Refer to "HFC-134a (R-134a) Service Procedure".
2. Remove the low-pressure pipe.
CAUTION: Cap or wrap the joint of the pipes with suitable material such as vinyl tape to avoid the entry of air.
INSTALLATION
Installation is in the reverse order of removal. Refer to "Components".
CAUTION:
-
Replace the O-ring of the high/low-pressure pipe with a new one, then apply compressor oil to it when installing it.
-
After charging refrigerant, check for leaks.