Titan 4WD V8-5.6L (VK56DE) (2006)
/Page-1675010.png)
^
Slide the corrugated tube inside the door grommet about 10 mm. The second paint mark should just be visible (see Figure B6). You may need
to roll the grommet back and then forward over the tube.
^
At the body end, the corrugated tube should meet the vinyl tube with no gap. The paint marks must be facing away from the door/body as
shown in Figure B6.
10.
Install the new body clip over the paint mark on the body-side (see Figure B7).
^
Feed the strap through the buckle so the strap is UP as shown in Figure B7.
11.
Install the new hinge rod clip over the center paint mark (see Figure B7). Feed the strap through the buckle so the strap is UP as shown in Figure
B7.
12.
Cut off the excess strap. Leave only 3 to 6 mm (1/8 to 1/4 inch).
