Titan 4WD V8-5.6L (VK56DE) (2006)
Accelerator Pedal: Service and Repair
Non-Adjustable Accelerator Pedal Assembly
ACCELERATOR CONTROL SYSTEM
Removal and Installation
NON-ADJUSTABLE ACCELERATOR PEDAL ASSEMBLY
CAUTION:
-
Do not disassemble the accelerator pedal assembly.
-
Do not remove the accelerator pedal position sensor from the accelerator pedal bracket.
-
Avoid damage from dropping the accelerator pedal assembly during handling.
-
Keep the accelerator pedal assembly away from water.
Removal
1. Turn the ignition switch OFF and disconnect the negative battery terminal.
2. Disconnect the accelerator position sensor electrical connector.
3. Remove the two upper and one lower accelerator pedal nuts.
4. Remove the adjustable accelerator pedal assembly.
CAUTION:
-
Do not disassemble the accelerator pedal assembly.
-
Do not remove the accelerator pedal position sensor from the accelerator pedal bracket.
-
Avoid damage from dropping the accelerator pedal assembly during handling.
-
Keep the accelerator pedal assembly away from water.
Installation
Installation is in the reverse order of removal.
Inspection After Installation
-
Check that the accelerator pedal moves smoothly within the specified range.